X10 Wireless Technology Home Security System IN37A User Manual

SETUP  
INSTRUCTIONS  
Setting Up an X10® Multi-Camera System  
up, turn it off using your CR12A. Repeat these  
steps for each camera you are setting up. Make  
sure to choose a different Unit Code for each  
camera.  
Configure Your Cameras in XRay  
Vision  
Your X10 multi-camera system allows you to control  
X10 XCam2™ cameras from your PC and view  
each camera from the XRay Vision™ software.  
Follow these instructions to set up the necessary  
hardware and software. You should have previously  
installed XRay Vision on your PC before starting  
these steps.  
Run XRay Vision. Right click in the  
program window and choose "Settings"  
then "Preferences" from the pop-up menu. Click  
on the "Cameras" tab in the configuration window.  
Click on the "Add" button to create an entry for  
a camera. Click into the "Camera Code" box and  
enter the House and Unit code for this camera.  
Make sure to enter the letter and number without  
a space between them. In the "Comment" box  
you can type a description or name for this  
camera. Repeat these steps for all the cameras  
you set up earlier.  
Set Up the Transceiver Module  
Make sure you have connected the  
Transceiver (model TM751) to a nearby  
power outlet. The outlet you use should not be  
too close to the back of your PC, as  
your PC may create some electrical  
noise that could reduce the range  
of the transceiver. Set the House  
Code (letter dial) on the Transceiver  
to the letter you will use for your  
cameras.  
You are now ready to control your cameras from  
XRay Vision. Right click in the XRV window and  
choose "Camera." You will be able to select from  
your different cameras, or tell XRV to  
automatically switch between all of them.  
Connect the Firecracker Computer  
Interface  
For more help, see:  
The Computer Interface (model CM17A)  
uses wireless signals to transmit X10 control  
commands from the computer to the transceiver  
module included in the kit. Connect the Interface  
directly to your PC's serial port. If  
there is already a device connected  
to this port, unplug it, connect the  
Computer Interface, and then plug  
the other device into the connector  
on the CM17A. Important: Do not  
plug your mouse into the CM17A!  
Set Up Your Cameras  
Set the House and Unit code on the  
addressable power supply (model  
XM10A). All of the cameras you set up will be set  
to the same letter (House) code, and each will have  
its own number (Unit) code. Plug the power supply  
into a free AC outlet. Connect the camera to the  
power supply. The camera should come on and  
you should be able to get the picture on the TV.  
Adjust the antenna so that it points better at the  
antenna of the receiver. When the camera is set  
MODEL  
NUMBER:  
IN37A  
©Copyright 2000 X10 Wireless Technology, Inc.  
 

Westinghouse Flat Panel Television DWM55F1Y2 User Manual
Whirlpool Clothes Dryer 8527795 User Manual
Whirlpool Dishwasher DP840 User Manual
Woods Equipment Lawn Mower 7000, 7192, 7194, 7195, 7200, 7205 User Manual
Worksaver Compact Loader DCR 4 User Manual
X10 Wireless Technology Intercom System VR55A User Manual
Zanussi Cooktop 200230 User Manual
Zanussi Freezer ZUF 105W User Manual
Zanussi Refrigerator ZUD 9124 User Manual
Zanussi Washer ZWN 1220 W User Manual